NYLENE 201L
TECHNICAL DATA SHEET

 
General Description    

  • Lubricated, nucleated nylon 6 molding resin designed for faster molding cycle times and lower part shrinkage
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Specific Gravity
D 792
1.14
Mold Shrinkage
in/in
0.011
 
Mechanical Properties
Test Method
Units
Dry as Molded
Tensile Strength
D 638
psi (MPa)
11,500 (79)
Elongation @ Break
D638
(%)
10
Flexural Modulus
D790
psi (MPa)
382,000 (2,630)
Notched Izod @ 23 °C
ftlbf/in (J/m)
D 256
0.8 (45)
 
Thermal Properties Test Method Units
Dry as Molded
DTUL @ 1820 kPa
D 648
°F (°C)
136 (58)
Melt Point
D3418
°F °C
433 (223)
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/09/23