NYLENE 7250C HS
TECHNICAL DATA SHEET

 
General Description    

  • Glass and ceramic fiber reinforced nylon 6 injection molding material
  • Designed to provide high dimensional stability, very high stiffness, and a hard surface, while maintaining the heat and chemical resistance typical of nylon products
  • Suitable for such uses as valve bodies, pump housings, hydraulic fittings and couplings, and other applications which require this unique set of characteristics
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Specific Gravity
D792
1.59
 
Mechanical Properties
Test Method
Units
Dry as Molded
Tensile Strength
D638
psi MPa
18,000 (124)
Flexural Modulus
D790
psi MPa
1,500,000 (10,345)
Notched Izod @ 23 °C
D256
ft. lb./ in. J/m
1.3 (70)
 
Thermal Properties Test Method Units
Dry as Molded
Melt Point
D3418
°F °C
420 215
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/09/23