NYLENE NX4301
TECHNICAL DATA SHEET

 
General Description    

  • High viscosity, UV stabilized extrusion grade nylon resistant to degradation by ultraviolet light
  • The elevated quality of UV resistance is attributed to highly uniform dispersion of 2% carbon black
  • With an ASTM viscosity of 200, NX4301 has very good melt flow and melt strength characteristics which are important for profile extrusion
  • Optimum processing conditions should permit for a melt temperature of 550 - 575°F at the die. (Available in black only)
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Specific Gravity
D792
1.17
 
Mechanical Properties
Test Method
Units
Dry as Molded
Tensile Strength
D638
psi MPa
10,200
Elongation
D638
%
140
Notched Izod @ 23 °C
D256
ft. lb./ in. J/m
1.0
Flexural Strength
D790
psi
17,000
 
Thermal Properties Test Method Units
Dry as Molded
HDT @ 264 psi
D648
°F
144
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/09/23