NYLENE 132-250
TECHNICAL DATA SHEET

 
General Description    

  • High viscosity (200 RV), extrusion grade nylon 6/6 recommended for practically all types of extrusion including profile, film and extrusion coating
  • Has good melt flow and melt strength properties
  • Optimum processing conditions should permit for a melt temperature of 550°F -575°F at the die
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Specific Gravity
D792
1.14
 
Mechanical Properties
Test Method
Units
Dry as Molded
Tensile Strength
D638
psi MPa
12,000 (83)
Elongation at Break
D638
%
50
Flexural Modulus
D790
psi MPa
415,000 (2860)
Notched Izod @ 23 °C
D256
ft. lb./ in. J/m
1.1 (59)
 
Thermal Properties Test Method Units
Dry as Molded
Melt Point
D3418
°F °C
490 (254)
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/09/22