NYLENE 826
TECHNICAL DATA SHEET

 
General Description    

  • Copolymer suitable for both blown and cast film co-extrusion
  • Has a lower melt point and is less crystalline than standard nylon 6 resins
  • Excellent toughness, chemical resistance, transparency, and low oxygen permeability, superior deep-drawing characteristics
  • Effective processing is achieved with extruder and die temperatures in the range of 450 - 525°F
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Specific Gravity
D792
1.11
 
Mechanical Properties
Test Method
Units
Dry as Molded
Yield Tensile Strength
D882
psi MPa
3845 26.5
Ultimate Tensile Strength
D882
psi MPa
8650 60
Elongation
D882
%
365
 
Thermal Properties Test Method Units
Dry as Molded
Melt Point
D3418
°F °C
385 196
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/09/23