NYLENE 405 HS
TECHNICAL DATA SHEET

 
General Description    

  • Medium viscosity nylon 6 with lubrication and heat stabilization
  • Made for Injection molding applications requiring good physical properties including toughness and rapid cycle times
  • Optimum processing conditions could provide a melt temperature of 460°F-500°F at the nozzle
 

Properties   

Physical Properties
Test Method
Units
Dry as Molded
Density
ISO 1183
g/cm3
1.13
Moisture Content
ASTM D6869
%
< 0.20
 
Mechanical Properties
Test Method
Units
Dry as Molded
Yield Tensile Strength
ISO 527
MPa
75
Flexural Modulus
ISO 178
MPa
2400
Charpy
ISO 179-1
kJ/m2
5
 
Testing conducted on dry-as-molded specimens at 73°F
 
Notes
All values are for dry as molded specimens. The data set forth herein has been carefully compiled by Polymeric Resources Corporation. Values shown are typical properties and are not for specification. Since processing variables will affect properties, the reproducibility of our data in a customer's facility is not guaranteed. There is no warranty of any kind either expressed or implied, applicable to the use of this information, and the user assumes all risk and liability in connection therewith.



Issued: 2009/10/14